JBL SDP-40 Stereo System User Manual


 
Troubleshooting & Maintenance
JBL
6-2
TROUBLESHOOTING
The SDP-40 does not power on.
1. Make sure the rear panel power switch is set to the|(“on”)
position.
2. Attempt to deactivate standby mode with both the front panel
and remote control standby buttons.
3. Examine the power cord to ensure a solid connection between
the AC input connector and the wall outlet.
4. Examine the electrical circuit and breaker.
The remote control does not work.
1. Eliminate obstructions between the remote control and the
front panel IR receiver. When the SDP-40 is not using the rear
panel IR IN connector, the remote control must be in line-of-
sight with the front panel IR receiver for proper operation. The
remote control might also become unreliable if strong sunlight
or fluorescent light is shining on the IR receiver.
2. Make sure the remote control batteries are correctly inserted
with the proper polarity.
3. Replace the remote control batteries. When the batteries are
low on power, the remote control enters a low-voltage
condition that prevents it from operating the SDP-40.
The SDP-40 is powered on, but there is no audio.
1. Examine the audio cables to ensure a solid connection between
the SDP-40 and all associated power amplifiers.
2. Make sure volume is set to an audible level. Volume level can
be increased with the front panel volume knob or the remote
control VOL + and – buttons.
3. Make sure audio has not been muted. The message “MUTE
ON” or “FULL MUTE ON” will appear on the on-screen and
front panel displays when audio has been muted. To deactivate
mute, press the Mute button or adjust volume level.
4. Check the INPUT SETUP menu DIGITAL IN and ANALOG IN
parameters to make sure the appropriate audio connector is
assigned to the selected input.
5. Make sure the SDP-40 is receiving an audio signal. To do this,
follow the instructions that begin on page 2-20 to open the
status menu for the current input source.
6. Make sure all associated power amplifiers are powered on.
Dialog sounds muffled.
1. If the speaker setup does not include a center speaker, make
sure a custom – as opposed to a THX – speaker setup is selected.
Then, make sure the CUSTOM SETUP menu CENTER parameter
is set to NONE.