84 HP Digital Entertainment Center
Satellite Connection
One Satellite Receiver
Connect the TV signal source from the satellite receiver
into the HP Digital Entertainment Center.
If you are using a satellite receiver (not provided) with
S-video or composite video output, do the following:
1 Make sure that a coaxial cable connector from your
dish source is plugged into the satellite receiver In
connector.
2 Connect a video cable.
a Choose a Video Out connector:
■ Coaxial (RF)
■ Video (composite)
■ S-video
b Connect the video cable from the
satellite receiver back panel video output
connector.
c Connect the video cable into the HP Digital
Entertainment Center back panel TV Source 1 In
connector.
3 Connect stereo audio cables (skip this step if using
coaxial [RF]):
a From the satellite receiver back panel Audio Out
right (red) connector and Audio Out left (white)
connectors.
b Into the HP Digital Entertainment Center back
panel TV Source 1 In Audio right (red) and Audio
left (white) connectors.
4 Connect the satellite receiver Infrared Transmitter
cable (required for signal). See “Infrared Transmitter
Connection” on page 88.