Filter
Top Products
132 HP Digital Entertainment Center
Configuring Audio Output
You must adjust the audio settings in two places after you
have installed and connected the HP Digital Entertainment
Center to your audio system.
Configure both the Media Center speaker settings and
audio for the DVD player.
The following table shows which procedures to perform
for your audio system. If you set up speakers using the
Media Center Optional Settings wizard, then set up the
audio for the DVD player only.
Media Center
speaker
settings
(TV Audio)
DVD audio
setting Procedure
2
(default)
2 speakers;
Dolby Surround
Compatible
(default)
Default, no audio output configuration required.
5.1 5.1 Change Settings in “Configuring audio for Media Center” on page 133
and “Configuring audio for the DVD Player” on page 133.
7.1 7.1 Change Settings in “Configuring audio for Media Center” on page 133
and “Configuring audio for the DVD Player” on page 133.
Digital Audio
SPDIF on
(default)
Digital Audio
SPDIF off
(default)
Change Settings in “Configuring audio for the DVD Player” on
page 133.
If you use digital audio, the Media Center SPDIF default
setting is on, but the DVD Player SPDIF default setting is
OFF. You must change the DVD SPDIF default setting to ON
to hear all channels in DVD digital audio.