Filter
Top Products
52
Installing the Bracket
Installing MTBR-07S(BT77) Bracket for Infrared Receiver RC-07 and
Achiever Receiver/Amplifier
Please carefully read the following assembly, installation and safety
instructions before installation of MTBR-07S Bracket for Infrared Receiver
RC-07 and Achiever Receiver/Amplifier.
1. Installation Surface
– The enclosed accessories are suitable only
for attaching to walls made of solid concrete or wood studs. Do not
install to sheet rock or wood panel.
2. Tighten all the nuts using appropriate wrench.
3. Make sure that MTBR-07S Bracket is installed so the tray is above
average head height and doesn’t disturb free movement in hallways.
4. You must test the MTBR-07S Bracket before
setting Infrared
Receiver RC-07 or Achiever Receiver/Amplifier.
5. The maximum weight allowed on the mount is 55 lbs.
6. Check that the Infrared Receiver RC-07 or Achiever
Receiver/Amplifier is securely fastened to the bracket so it will not
fa ll forward.
7. One month after installation and every six months after that, check
that MTBR-07S Bracket is securely fastened to the wall and the
screws and nuts are not loosening. In case of weakening, remove
Infrared Receiver RC-07 or Achiever Receiver/Amplifier, and
strengthen all the points that have weakened.
8. Before reinstalling MTBR-07S Bracket, remove the Infrared
Receiver RC-07 or Achiever Receiver/Amplifier, first and then
remount according to this manual instructions.