Filter
Top Products
16
Rear Panel Connections
ULTIMATE IISE
(1) DC power supply terminal [24 V IN, 1.2 A] Connect the specified AC adaptor
(accessory), and it supplies 24 V DC power.
(2) Sensor input terminal [SENSOR INPUT 75Ω
(3) Line input terminals - [LINE INPUT 1,2,3,4 –20dBV 10k Ohm] Connect exter-
nal audio device (such as DVD etc).
(4) Line Output terminals [LINE OUTPUT 0dBV 600 Ohm]. Connect to recording
or external audio device. Output jack is 3.5mm Tip/Sleeve (monaural).
(5) Auto mute switch [AUTO MUTE OFF/LOW/HIGH] When activated, the mi-
crophone can interrupt the external audio device by reducing its volume. Detec-
tion sensitivity is controlled by the “LOW” and “HIGH” setting.
(6) Feedback blocker switch [FEEDBACK BLOCKER OFF/ON] Turn this switch
OFF to disable feedback blocker. Default is OFF.
(7) Function terminals [PA OVERRIDE INPUT, BIAS/CNT/GND] See “Function”
Page.
(8) Jumper pin—Used to set up Enable/Disable of the PA override function. Default
setting is Disable
(9) Speaker Output terminals - Use speakers with impedance of 8 Ohms. Two
speakers can be connected each of the four amplifiers.
(10) Ground screw [SIGNAL GND] - When the amplifier is used with a combina-
tion of external devices, connect the earth terminal of each device to reduce the
difference in potentials between devices.
(11) Mount for cable clamp.