Filter
Top Products
51
Installing the Bracket
Installing the UltimateII and Innovator Receiver Amplifier on MTBR-07L
Install the Ultimate II and Innovator Receiver/Amplifier as described
below.
1. Fix the main unit to the bracket.
Use 2 screws to fix the bracket to the side of main unit.
2. After installation, make sure nothing is loose.
Do a visual check and make sure that nothing is unsteady and the
screws are tight.
Warning for the Installation the Bracket
Fix the bracket and the wire lope to the wall.
Please secure enough strength for the installed wall.
Wire Lope Requirement
Diameter : more thanφ1/16 inches
Material : High carbon steel wire rods
Caution: Please confirm to the wall there is enough strength to support the Infra-
red receiver with the bracket. 106KG is five times weight about the sensor neces-
sary above. Please do not install it in plasterboard. Please reinforce it when strength
is insufficient. Please secure the AC adapter as follows when it is required to be
installed higher than 30 inch from floor.
*Use metal tie-wrap and tie up two parts with something secure, 1) the
brick of the AC adapter (make sure tie it using more than two tie-wraps apart from
each other, 2)DC side cable at the very close point to the brick.
To the wall
Wire lope
MTBR-07L (STC-98014)
Bracket