Filter
Top Products
40
Installation
Installation Bracket:
Diagram for bending
Bend it according to the
grooves.
Anchor strap
Coaxial cable
Adjuster
Ceiling panel Installation-
bracket
Installation
screw
Screws
●Installing the Sensors: Part 2
If the coaxial cables cannot be routed through the ceiling, you can install the
sensors as shown below if the ceiling panels cannot be removed.
1. Bend the installation bracket. Bend the installation bracket as shown in the
diagram above.
2. Attach the installation bracket to the ceiling. Attach the installation bracket
to the ceiling with the screws.
3. Attach the anchor strap. Put coaxial cable through the anchor strap and
tighten the adjuster.
4. Install the sensor. Put the screw through the sensor and screw it into the instal-
lation bracket. Tighten the screws.
5. After installation, make sure nothing is loose. Do a visual check and make
sure that nothing is unsteady and the screws are tight.
Caution: The screws for attaching the installation bracket to the ceiling panel are
not provided. Procure these screws separately according to the material, construction
and weight of the ceiling panel.