Filter
Top Products
49
Precautions for Installation
● Precautions for Installing the Infrared Receiver and Infrared Receiver/Amplifier
◎Infrared Receiver and Infrared Receiver / Amplifier will produce small amounts of heat.
Provide a minimum of 10 cm when installing the amplifier close to the ceiling or wall.
Infrared Receiver and Infrared Receiver / Amplifier are for indoor use only.
They cannot be installed and used in any of the situations below:
・In a place where they can get wet.
・Where chemicals are used including under the eaves (ex. pool)
・Places that contain high amounts of steam, oil, or a flammable atmosphere.
・Places where radiation, such as X-ray or high radio waves magnetism are present.
・On the ocean, beach or place where corrosive gas, such as hot spring is present.
・In a place where high levels of vibration are present such as on a vehicle, or marine ves
sel.
◎When using the provided bracket, note the following points.
・Select a sturdy wall to install.
・Insure that the appropriate fasteners or screws are used, and that they are rated appro
priately for the load they will be required to carry.
・Insure that all the all directions from the manufacturer of the anchor, fastener or screw
are followed.
・Do a visual check and make sure that nothing is unsteady and the screws are tight.
◎Note the following points when tightening bolts and screws.
・Proper torque must be applied to all bolts and screws.
・A torque wrench or a torque driver are required to set the proper torque.
・It is difficult to get the proper torque with an impact driver or electric driver even if it has
a clutch; therefore, they should not be used as they may damage the parts for the installa
tion.
◎Note the following points when installing the Innovator or Ultimate II Infrared Receiver/
Amplifier into a rack.
・When mounting to a rack, remove the rubber feet from the base of the unit.
・When installing near other heat-sensitive equipment, install the other equipment lower
than the receiver/amplifier system.
・Install rack in a such a manner as to provide for sufficient airflow to maintain a tempera
ture of no more than 40 in the rack.
More
Than 10
cm
More
Than
10 cm
More
Than
10 cm
Front
side