Filter
Top Products
32
Installation
This connection diagram is an example of using 3 to 4 infrared wireless mi-
crophones with the "Innovator" infrared receiver/amplifier. When using only
two microphones, one of the “EDS-07”sensors and the “AE-DCF” mixer are
not necessary. In that case, set the "frequency selector switch" on the sensor
according to the microphone channels being used.
If you are connecting the "Ultimate II“ receiver amplifier, one or two infra-
red wireless microphones can be used. With this configuration one of the
"EDS-07" sensors and the "AE-DCF" mixer are not necessary. With this con-
figuration, set the "frequency selector switch" on the sensor to 1/2: 1ch and
2ch.
Innovator
EDS-07
DVD recorder
Specified AC adapter
PW-150A2-1Y-240E
Coaxial cable
Pin plug (stereo type)
F-connector
Coaxial cable
Coaxial cable
AE-DCF
1/2: 1ch/2ch
3/4: 3ch/4ch
Bundle the cables with tie wraps and
fasten them to the "mount for the cable clamp".
AC 120 V
50/60 Hz