Filter
Top Products
50
Installing the Bracket
Installing MTBR-07L(STC-98014) for the Ultimate II and Innovator Receiver
Amplifier Please carefully read the following assembly, installation and safety
instructions before installation of MTBR-07L Bracket for Ultimate II and
Innovator Receiver Amplifier.
1. Installation Surface
– The enclosed accessories are suitable only for
attaching to walls made of solid concrete or wood studs. Do not
install to sheet rock or wood panel.
2. Tighten all the nuts using the wrench supplied with the mount. The
nub must be tightened until the threading of the screw passes the
plastic part of the nut.
3. Make sure that MTBR-07L Bracket is installed so the tray is above
average head height and doesn’t disturb free movement in hallways.
4. You must test the MTBR-07L Bracket before
setting Ultimate II or
Innovator Receiver Amplifier.
5. Calculate the maximum weight allowed on the mount by
multiplying the specified weight (this weight will be specified in
the packaging of the bracket) by 1.75. (I.e. weight x 1.75).
6. Check that Ultimate II or Innovator Receiver Amplifier is securely
fastened to the bracket so it will not fall forward.
7. One month after installation and every six months after that, check
that MTBR-07L Bracket is securely fastened to the wall and the
screws and nuts are not loosening. In case of weakening, remove
Ultimate II or Innovator Receiver Amplifier, and strengthen all the
points that have weakened.
8. Before reinstalling MTBR-07L Bracket, remove Ultimate II or
Innovator Receiver Amplifier first and then remount according to this
manual instructions.