Filter
Top Products
40
3
Select the play mode.
STEREO
(Main unit) (Remote control unit)
Example: Stereo
4
Start playback on the selected component.
• For operating instructions, refer to the component’s
manual.
5
Adjust the volume.
M.VOL. -80.0dB
MASTER VOLUME
(Main unit) (Remote control unit)The volume level is displayed
on the master volume level
display.
Figures of 0.5 dB and below
are rounded down.
The volume can be adjusted within the range of –80 to 0 to 18 dB,
in steps of 0.5 dB. However, when the channel level is set as
described on page 24 or page 48, if the volume for any channel is
set at +1 dB or greater, the volume cannot be adjusted up to 18
dB. (In this case the maximum volume adjustment range is “18 dB
— (Maximum value of channel level)”.)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “AUTO” or “DTS”.
Input mode display
ANALOG DIGITAL
DIGITAL
DIGITAL
DIGITAL
ANALOG
RF
AUTO
PCM
DTS
INPUT MODE
RF
AUTO
PCM
DTS
INPUT MODE
RF
AUTO
PCM
DTS
INPUT MODE
RF
AUTO
PCM
DTS
INPUT MODE
RF
AUTO
PCM
DTS
INPUT MODE
• In the AUTO mode
• In the PCM mode
• In the DTS mode
• When switched to RF in the VDP RF or AUTO mode
One of these lights, depending on the
input signal.
Input signal display
PRO LOGIC
LOCK
DIGITAL
INPUTSIGNAL
LOCK
DIGITAL
INPUTSIGNAL
LOCK AL24
DIGITAL
INPUTSIGNAL
• DOLBY DIGITAL
• DTS
• PCM
One of these lights, depending on the
input signal.
The AL24 indicator lights when the PURE DIRECT, DIRECT or
STEREO mode is selected in the digital input mode.
The LOCK LED lights when digital signals are being input properly.
If the LED does not light, check whether the digital input
component setup (page 29) and connections are correct and
whether the component’s power is turned on.
NOTE:
• The digital input indicator will light (green) when playing CD-
ROMs containing data other than audio signals, but no sound
will be heard.
After starting playback
[1] Adjusting the sound quality (tone)
The tone control function will not work in the Direct or Home THX Cinema mode.
1
Press the MODE SELECT button and select
TONE.
The mode switches as follows each time
the MODE SELECT button is pressed:
2
Select BASS/TREBLE with the
FUNCTION knob.
MODE
SELECT
• In the ANALOG mode
FUNCTION
4 2 31
SURR.
PARAMETER
TONE
CONTROL
CH. VOL.
(* TUNER PRESET)
(Main unit)
(Main unit)
Only displayed when the TUNER input is
selected.