Filter
Top Products
33
Setting the Ext. In Setup
• Set the method of playback of the analog input signal connected to the Ext.In-1 and Ext.In-2 terminal.
1
At the System Setup Menu select “Ext.In Setup”.
2
Switch to the Ext.In Setup screen.
3
q Select the input terminal. w Switch to the setting screen.
MODE:
DSP: The analog input signal is converted into a digital signal and undergoes DSP processing.
System Setup settings (speaker configuration, channel delay, etc.) are reflected in the same way as for other input signals.
ANALOG: The analog input signal is played without DSP processing.
SW and center channel: Down-mixing is conducted by the analog circuit. Surround and surround back channels: Not output
if “No” is selected at the speaker configuration. Channel delay: Not reflected.
S.Back:
Set when MODE is set to DSP. Select according to the specifications of the player being used. Also refer to the player’s operating
instructions.
NOT USE: Select when neither SBL or SBR is connected.
SB (SBL): Select when only one surround back channel (SBL) is connected.
SBL/SBR: Select when two surround back channels (SBL and SBR) are connected.
SW Level:
Select according to the specifications of the player being used. Also refer to the player’s operating instructions.
+15dB (default) recommended. (0, +5, 10 and +15 can be selected.)
INPUT Vol.:
Set when MODE is set to DSP.
If the OVER LOAD indicator is displayed on the fluorescent tube, adjust the input level to between 0 and -20 dB.
5
Enter the setting.
The System Setup Menu reappears.
4
Select the item to be set (push the jog stick to the
up and down) then select the parameter (push the
jog stick to the left and right).