Filter
Top Products
19
Before setting up the system
1
Check that all the connections are
correct, then turn on the main unit’s
power.
2
Either lightly press on the remote control unit’s touch panel
or press the LIGHT button to turn on the liquid crystal display.
(The back light does not turn on when the touch panel is
pressed.)
3
By default the liquid crystal display is set to display for 30
seconds, but this can be changed to approximately 120
seconds using the procedure described below so that
operations during system up can be performed securely.
4
Lightly press the remote control unit’s
jog stick (PUSH ENTER) to display the
icon display section.
5
Press the “” button in the icon display section to display
the “SETUP” icon.
6
Press the “SETUP” icon for at least 3 seconds to display
the setup screen.
8
Press the “” button in the icon display section to display
the “AVAMP” icon.
Press the “AVAMP” icon to display the page section.
ON / STANDBY
(Main unit)
1