Filter
Top Products
95
Advanced Operation
Multi-source recording / playback
1
Press the ZONE3/REC SELECT button until
“RECOUT SOURCE” appears on the display.
• The “REC” indicator lights.
2
Turn the FUNCTION knob to select the source
you wish to record.
3
Set the recording mode.
For operating instructions, refer to the manual of the
component on which you want to record.
RECOUT SOURCE
DVD
¢
Playing one source while recording another
(REC OUT mode)
¢
Recording Dolby Digital and DTS multi channel
sources
•With this set it is possible to record Dolby Digital and DTS
multichannel signals converted into 2-channel analog
signals.
• The recording signals are output to the TAPE and VCR
output terminals.
• Down-mixed analog signals converted into digital signals
are output from the OPTICAL 2, 3 and 4 digital output
terminals at this time.
1
Press the ZONE3/REC SELECT button until
“RECOUT SOURCE” appears on the display.
2
Press the INPUT MODE button to set the input
mode according to the source to be played.
3
Press the DIRECT/STEREO button to set the
surround mode.
• The multichannel digital signals are down-mixed and
output to the TAPE and VCR output terminals.
4
Set the recording mode.
•To cancel, turn the FUNCTION knob and select “SOURCE”.
• Recording sources other than digital inputs selected in the
REC OUT mode are also output to the ZONE3 audio/video
output terminals.
• When the REC OUT mode is selected, the ZONE3 button on
the remote control unit cannot be operated.
• When “ZONE2 SELECT” is selected at “Digital Out Assign”,
the source switches in association with the “ZONE2
SELECT” mode for the OPTICAL2 OUT terminal ( page
121).
1
The Dolby Headphone play mode is set when
headphones are connected to the
PHONES jack
during playback in the DOLBY/DTS surround
mode.
• When this is done, signals encoded in the Dolby
Headphone mode are automatically output from the
recording output terminals (analog and digital) and
can be recorded.
2
Select the parameters and set the desired
mode.
• Start recording.
Refer to the “Dolby Headphone” ( page 59).
NOTE:
• Do not disconnect the headphones during recording.
¢
Dolby Headphone recording
• When REC OUT mode is set to “SOURCE”, with the AVR-
4806CI it is possible to output signals encoded in the Dolby
Headphone mode from the recording output terminal and
record them on a separate recorder.