Filter
Top Products
136
Advanced Setup – Part 2
Check the parameter
1
Press the CURSOR
DD
or
HH
button to select
“Parameter Check” at the “Auto Setup / Room
EQ” menu, then press the
ENTER button.
• Display the “Parameter Check” screen.
• The results of the measured items can be checked.
• The EQ parameters that were set in Auto Setup can be
checked.
• This item is displayed, after the measurement result of the
“Auto Setup / Room EQ” is decided.
2
Press the CURSOR
DD
or
HH
button to select the
items, then press the
ENTER button.
• Display the verification screen.
For instructions on checking the results of each item
( page 24).
3
Press the CURSOR
DD
or
HH
button to select “EQ
Parameter Check”, then press the
ENTER
button.
• Display the “EQ Parameter Check” screen.
4
Press the CURSOR
DD
or
HH
button to select the
Equalizer curve, then press the
ENTER button.
• Display the “EQ Check” screen.
The display is only an approximate picture of the
response and that correction is happening at all
frequencies.
5
Press the CURSOR
FF
or
GG
button to select the
speaker channel.
6
If the check ends, pressing the CURSOR
DD
or
HH
button to select “Exit”, then press the
ENTER
button.
• The “EQ Parameter Check” screen reappears.
7
Press the CURSOR
DD
or
HH
button to select
“Exit”, then press the
ENTER button.
• The “Parameter Check” screen reappears.
The results of the “Auto Setup” procedure can
be reset even if the settings have been changed
after performing the “Auto Setup” procedure:
Press the
CURSOR
DD
or
HH
button to select
“Restore Yes
0
”, then press the CURSOR
FF
button.
8