Filter
Top Products
121
Advanced Setup – Part 1
Setting the Digital Out Assignment
• The optical digital output terminals on the AVR-4806CI’s rear
panel (OPTICAL2 to 4 OUT) normally function in association
with the ZONE3/REC SELECT mode. With this setting, the
OPTICAL 2 OUT terminal can be used in association with the
ZONE2 SELECT mode.
1
Press the CURSOR
DD
or
HH
button to select
“Digital Out Assign” at the “Option Setup”
menu, then press the
ENTER button.
• Display the “Digital Out Assign” screen.
2
Press the CURSOR
FF
or
GG
button to select
whether to associate the OPTICAL2 OUT
terminal to the “ZONE3/REC SELECT” or
“ZONE2 SELECT” mode.
3
Press the ENTER button to enter the setting.
• The “Option Setup” menu reappears.
User Memory
• The currently set settings (system setup, surround
parameters, etc.) can be stored in the memory. The stored
settings can be called out when needed.
1
Press the CURSOR
DD
or
HH
button to select
“Setup Memory / Lock” at the “Option Setup”
menu, then press the
ENTER button.
• Display the “Setup Memory / Lock” screen.
2
Press the CURSOR
DD
or
HH
button to select
“User Memory”, then press the
ENTER button.
• Switch to the “User Memory” screen.
3
Press the CURSOR
FF
button to select “Yes”.
• About 30 seconds are required for the settings to be
stored in the memory.
Once the settings are stored in the memory, “Load” is
displayed and the settings can be loaded.
4
Press the CURSOR
DD
or
HH
button to select
“Exit”, then press the
ENTER button.
• Return to the “Setup Memory / Lock” screen.