Denon AVR-4806CI Stereo System User Manual


 
112
Advanced Setup – Part 1
Setting the Dolby Digital Setup
Sets the down-mixing method when not using a center
speaker or surround speakers.
1
Press the CURSOR
DD
or
HH
button to select
“Dolby Digital Setup” at the “Advanced
Playback” menu, then press the
ENTER button.
Display the “Dolby Digital Setup” screen.
2
Press the CURSOR
FF
or
GG
button to select
“ON” if you want to use the Compression,
“OFF” if you do not want to use it.
OFF:
The dynamic range is not compressed.
ON:
The dynamic range is compressed automatically
according to the combination of speakers being
used.
Set “Compression” to “ON” if it seems that sound is
distorted because the input level exceeds the
allowable input for the front speakers.
When a center speaker or surround speakers are not
connected, the sounds in those channels are directed
to the front speakers.
3
Press the ENTER button to enter the setting.
The “Advanced Playback” menu reappears.
1
Press the CURSOR
DD
or
HH
button to select
“Auto Surround Mode” at the “Advanced
Playback” menu, then press the
ENTER button.
Display the “Auto Surround Mode” screen.
2
Press the CURSOR
FF
or
GG
button to select
“ON” if you want to use the auto surround
mode, “OFF” if you do not want to use it.
3
Press the ENTER button to enter the setting.
The “Advanced Playback” menu reappears.
Setting the Auto Surround Mode
The surround mode used at last for the four types of input
signals shown below is stored in the memory, and the signal
is automatically played with that surround mode the next
time it is input.
Note that the surround mode setting is also stored
separately for the different input sources.
q Analog and PCM 2-channel signals (STEREO)
w 2-channel signals of Dolby Digital, DTS or other multi-
channel format (DOLBY PL
IIx cinema)
e Multi-channel signals of Dolby Digital, DTS or other
multi-channel format (DOLBY/DTS SURROUND)
r PCM and DSD multi-channel signals other than Dolby
Digital and DTS (MULTI CH IN)
Default settings are indicated in ( ).
During playback in the PURE DIRECT mode, the
surround mode does not change even if the input signal
is changed.
The various settings applied in the auto surround mode can
be checked via the on screen display. Simply press the ON
SCREEN button ( page 51, 52).