Filter
Top Products
57 of 80
6.0 E4 System Setup
Programmer’s Note: If this process fails, a dialog
similar to the following will appear. Check the sensing
microphone installation and make sure all sources are
operating.
Following a successful microphone calibration, the software
automatically flashes the hardware to save the configuration.
10. At the end of a successful Auto Volume calibration, the soft-
ware displays a list of controls that are disabled when Auto
Volume is on. Click Finish to exit Auto Volume Setup. The
Auto Volume function is now On.
Resetting a calibrated Auto Volume zone
To cancel the calibration in an Auto Volume zone, click the Reset
button. The Reset button is available only after a zone is suc-
cessfully calibrated.
When you reset a calibrated Auto Volume zone, the keypad con-
trol programming is restored to that of a Standard Wall Plate the
next time you perform a hardware flash.
Programmer’s Note: Be sure you want to reset the
zone before you click the Reset button. If you reset the
zone, you will need to run the Auto Volume setup process
again before you can use Auto Volume.
Click to reset Auto Volume calibration