Filter
Top Products
Utility Mode - 27
D5000
REPEAT DELAY
This command is only available for the delay programs. It allows you to very rapidly create linear
delay programs. If you select a FREEZE or an S&H (sample and hold) program, this display page
will not appear.
You can check the effect on the TIME and LVL parameter of each tap of your delay program by
pressing the [ DELAY ] key.
REPEAT DELAY parameters
When you apply the Repeat Delay by pressing the [ < ] "STORE" CURSOR key, it sets the TIME and
LVL value for the specified taps. For example:
This results in the following delay program:
Press the [ UTILITY ] key to select the REPEAT DELAY command.
Use the [ ^ ] and [ % ] CURSOR keys to move through the various
parameters. Modify the selected parameter by rotating the DATA ENTRY
encoder.
To execute the repeat delay, press the [ < ] "STORE" CURSOR key.
REPEAT (1 ~ 6) Set the number of repeats.
Dual 1 ~ 3 repeats.
Single 1 ~ 6 repeats.
DELAY (0 ~ 5000 ms, 0 ~
1700 m, ~ )
Set the delay in milliseconds (time interval between repeated
sounds), metres, or note length.
DECAY (1 ~ 100) Set the decay in percentage (level of the last repeated sound).
NOTE
If you apply Repeat Delay to a delay program that has feedback turned on, the feedback level may be
boosted, causing an unpleasant howling. For the best results, turn the feedback off.
3
TIME(ms)
Decay=40%
Delay=
100%
Direct sound
Repeat 1
Repeat 2
Repeat 3
3