Filter
Top Products
16 - Parameter Edit Mode
D5000
Editing a sampling/playback program
To edit a sampling/playback program, press the [ DELAY ] key.
FREEZE program
The FREEZE program allows you to sample (digitally record) and playback sounds. You can record
in stereo for a maximum of 5.2 seconds or in mono for a maximum of 10.4 seconds. For playback,
you can adjust the pitch of the sample by up to ± two octaves.
There are four display pages:
• Page 1: Setting the recording parameters.
• Page 2: Setting the playback parameters.
• Page 3: Setting the pitch and MIDI note number.
• Page 4: Setting the title and controller assignments.
Page 1: Setting the recording parameters
This page allows you to specify the recording parameters for your freeze program.
FREEZE RECORD parameters
NOTE
You cannot store the recorded sample. Once the power is switched OFF, or if you select another
program, the recorded sample is erased from memory.
NOTE
To access the FREEZE program mode, you need to select one of the factory presets with the
PARAMETER COPY command in Utility Mode (refer to the preset list on page 30).
The
[ FB ] , [ MOD ] , and [ DUCK ] keys are inactive when a FREEZE program is loaded. To access
the FREEZE display pages, use the
[ DELAY ] key.
Press the [ DELAY ] key to switch to the first page of the FREEZE program.
Use the [ ^ ] and [ % ] CURSOR keys to move through the various
parameters. Modify the selected parameter by rotating the DATA ENTRY
encoder.
TRACK (STEREO/L-MONO) Select stereo or mono recording mode.
STEREO Stereo recording for a maximum of 5.2 seconds.
L-MONO Mono recording for a maximum of 10.4 seconds.
AUTO/MAN (MANUAL/AUTO) Set the recording method.
MANUAL Press the [ TRIGGER ] key or step on a footswitch
connected to the TRIGGER Footswitch Jack to put
the D5000 in standby mode. Recording will start
when you press the key or step on the footswitch
again.