Filter
Top Products
20 - Parameter Edit Mode
D5000
Page 4: Setting the title and controller assignments
This page is identical to Page 3 of the DELAY program (see page 11).
S&H (sample and hold) program
A sample and hold program allows you to record a sound (sample) and then play it back repeatedly
(hold). You can record in stereo for a maximum of 5.2 seconds or in mono for a maximum of 10.4
seconds.
There are two display pages:
• Page 1: Setting sample and hold parameters.
• Page 2: Setting the title.
Page 1: Setting the sample and hold parameters
Sample and hold parameters
FINE (-100 ~ +100) Fine tune the pitch by ±100 cents.
BASE KEY (OFF, C1 ~ C6) Specify the note that will be centre frequency for MIDI Note On
messages. The D5000 calculates the pitch change as the difference
between the BASE KEY and the note number of the pressed key.
For example, if the BASE KEY is set to "C3", then pressing C3 will
produce a Unison playback, while pressing C4 will shift the pitch
up one octave, and pressing G2 will produce a pitch change of 5
semitones down.
NOTE
If the BASE KEY parameter is set to OFF, pitch change cannot be controlled via MIDI Note On
messages.
NOTE
To access the S&H (sample and hold) program mode, you need to select one of the factory presets with
the PARAMETER COPY command in Utility Mode (refer to the preset list on page 30).
The
[ FB ] , [ MOD ] , and [ DUCK ] keys are inactive when an S&H program is loaded. To access the
S&H display pages, use the
[ DELAY ] key.
Press the [ DELAY ] key to access the first display page of the S&H (sample
and hold) program.
Use the [ ^ ] and [ % ] CURSOR keys to move through the various
parameters. Modify the selected parameter by rotating the DATA ENTRY
encoder.
TRACK (STEREO/L-MONO) Select stereo or mono recording mode.
STEREO Stereo recording for a maximum of 5.2 seconds.
L-MONO Mono recording for a maximum of 10.4 seconds.
NOR/REV Set the playback direction. NORMAL plays the sample back in the
normal direction. REVERS plays the sample back in reverse.