Filter
Top Products
12 - Parameter Edit Mode
D5000
Page 3: parameters
Adding feedback
To create a dense sounding effect, you can add feedback to each of the taps of the delay. You can
also invert the phase of the returning signal as well as filter out low and high frequency elements.
Feedback parameters
Press the [ DELAY ] key again to select the last display page.
Use the [ < ] , [ ^ ] , [ > ] , and [ % ] CURSOR keys to move through the
various parameters. Modify the parameter by rotating the DATA ENTRY
encoder.
TITLE (16 characters) Use the [ < ] and [ > ] CURSOR keys to move along the line of text.
Change the letter under the cursor by rotating the DATA ENTRY
encoder. The available characters are shown in the following
sequence:
ABCDEFGHIJKLMNOPQRSTU
VWXYZ abcdefghijklmnop
qrstuvwxyz ()[]<>:*+-=
/,.’%&!?# 0123456789
CTL.ASSIGN (OFF,
Parameter)
Select a parameter to be controlled by the MIDI control change
messages.
There are two controller channels, each of which can be assigned
any parameter of the current program (see page 25 for details).
MIN/MAX (0 ~ 100%) Set the range within which the parameter can be modified by the
control change messages.
Press the [ FB ] key to select FB (feedback).
Use the [ < ] , [ ^ ] , [ > ] , and [ % ] CURSOR keys to move through the
various parameters. Modify the selected parameter by rotating the DATA
ENTRY encoder.
Press the [ FB ] key again to enable or disable feedback. The status message
in the top corner of the LCD changes from "ON" to "OFF".
STATUS (OFF/NOR/INV) Select "OFF", positive phase (NOR), or negative (INV) phase.
TYP (→A, →B) Select which channel (A or B) will receive the feedback. This is
only available for DUAL (stereo) delay programs.
LVL (0 ~ 100%) Select the level of the feedback.