Filter
Top Products
Recording 25
CDR1000—Owner’s Manual
5 Recording
Preparing to Record
The CDR1000 can record onto CD-R and CD-RW discs.
1 Load the disc to be used for recording.
See “Loading & Unloading Discs” on page 18 for more information.
2 Select the input source.
See “Selecting the Input Source” below for more information.
3 If recording via the AES/EBU IN or COAXIAL IN, set the sampling rate con-
verter as necessary.
See “Setting the Sampling Rate Converter” on page 26 for more information.
4 Set the Copy Bit as required.
See “Setting the Copy Bit” on page 28 for more information.
5 Set the UV22 function as required.
See “Setting the UV22” on page 28 for more information.
6 Set the Delay function as required.
See “Setting the Input Delay” on page 27 for more information.
7 Proceed to Recording on page 29.
Selecting the Input Source
The following input sources can be selected for recording: ANALOG IN, AES/EBU IN,
or COAXIAL IN. The selected source is indicated on the display.
1 Use the [INPUT SELECT] button to select an input source.
When a digital input source is selected, the LOCK indicator lights up, indicating that
the CDR1000 is locked to the incoming signal. If the CDR1000 cannot lock to the
selected digital input source, the LOCK indicator flashes. If this unlocked condition
continues for more than five seconds while recording, recording stops. If this happens,
make sure that the source device is turned on and connected to the CDR1000 correctly,
or select another input source. Recording via the AES/EBU IN or COAXIAL IN is not
possible while the LOCK indicator is flashing.
Setting Description
ANALOG
ANALOG IN (analog)
AES/EBU
AES/EBU IN (AES/EBU digital)
COAX
COAXIAL IN (S/PDIF digital)