Filter
Top Products
18 Chapter 3—The Basics
CDR1000—Owner’s Manual
Loading & Unloading Discs
This section explains how to load and unload discs.
1 Press the [OPEN/CLOSE] button to open the disc tray.
The disc tray opens and “OPEN” appears on the display.
2 Place the disc in the center of the disc tray with the labeled side facing up.
3 Press the [OPEN/CLOSE] button again to close the disc tray.
The disc tray closes and “CLOSE” appears on the display.
If the disc tray opens again, make sure the disc is seated correctly in the disc tray.
The disc tray can also be closed by pushing it gently. Do not use excessive force to push
the tray when the CDR1000 is turned off, as this may damage the mechanism.
4 To unload a disc, stop the current operation, press the [OPEN/CLOSE] button
and remove the disc when the disc tray is fully open.
The following table lists the disc-related display messages and their meanings.
Disc Type & Status
When a disc is loaded, the CDR1000 determines the type and status of the disc, and
then the relevant disc-type indicator lights up, as shown in the following table.
Message Meaning
OPEN
The disc tray is opening.
CLOSE
The disc tray is closing.
READING
The CDR1000 is determining the type of disc and reading its table of
contents.
OPC
The CDR1000 is performing OPC (Optimum Power Control). See
“OPC” on page 4 for more information.
OPC OVER
The OPC area on the loaded disc is full. Load another disc. See “OPC”
on page 4 for more information.
NO DISC
No disc is loaded.
ERROR-xxxxxx
See “Error Messages” on page 54 for more information.
BLANK
An unrecorded disc is loaded.
UNRECORDABLE
The loaded disc cannot be used for recording. Finalize it, or load
another disc.
ROM
The loaded disc cannot be played because it contains data, perhaps it’s
a CD-ROM. Load another disc.
WAIT
The CDR1000 is writing the PMA. See “TOC & PMA” on page 4 for
more information.
OUT OF RANGE
The wordclock input signal is out of the range of the sampling rate
converter. See “Setting the Sampling Rate Converter” on page 26.
SELF-CHECK
The CDR1000 is initializing.
CHECK INPUT
The COAXIAL input must be selected to use Sync Recording. See
“Selecting the Input Source” on page 25 for more information.
NO CD
The loaded disc is not a CD, CD-R, or CD-RW. Load another disc.
Indicator Disc type/status
CD
A prerecorded audio CD or finalized CD-R disc
CD-R
Unfinalized CD-R disc
CD-RW
CD-RW disc