25
Basic operations
RQT5471
A
2
3
1
2
3
B
C
32,4
TUNING MODE
SET
SET
SET
SET
4
TUNER/
BAND
∂ VOLUME µ
MHz
?
TUNING
@
ENTER
RETURN
3D AI EQ/
M.EQ BAND
AV EFFECT
H
ANGLE
SLEEP
MARKER
TOP MENU
SUBTITLE
123
456
7890
j/-/--
DISC
PLAY MODE
CANCEL
AUDIO
U
PRO LOGIC
CH SELECT
TEST
DIGITAL
S.WOOFER
SUPER SRND
⁄/g¤»
∂VOLUME µ
VCR(EXT)/
VDP(AUX)
TAPE/
DECK 1/2
TUNER/
BAND
DVD
SLOW/SEARCH
MUTING
SKIP
SHIFT
MENU
EQ
SETUP
DISPLAY
MIX 2CH
2
1
3
123
456
7890
j/-/--
a Preset channel
The radio: preset tuning
You can choose either automatic presetting, which presets all the
stations the tuner/amplifier can receive, or manual presetting, which
allows you to select the stations to preset and the order they are to be
preset in.
There are 39 channels available for presetting.
»
A
Automatic presetting
Do the following once each for FM and AM.
Preparation: Tune to the frequency where presetting is to begin
(á page 24).
Hold down [SET].
Release the button when “AUTO MEMORY” appears.
The tuner presets all the stations it can receive into the channels in
ascending order. FM stations are preset into channels 1 to 39, and
AM stations are preset into channels 21 to 39.
“SET OK” is shown when presetting is complete and the last station
that was preset is played.
“ERROR” is displayed if the tuner doesn’t receive any stations. Try
presetting manually if this happens (see below).
Note
AM stations replace any FM channels that were preset in channels
21 to 39.
»
B
Manual presetting
Preset the stations one at a time.
1 Tune to the required station.
2 Press [SET].
3 Press [TUNING (X or W)] to select a
channel.
4 Press [SET].
The station occupying a channel is erased if another station is preset
in that channel.
»
C
Selecting channels
On the remote control
1 Press [TUNER/BAND].
2 Press the numbered buttons to select
the channel.
For channels 1 to 9 press the corresponding number.
For channels 10 or over press [L], then the two digits.
e.g. To select channel 21: [L]>[2]>[1]
3 Adjust the volume.
On the main unit
1 Select “PRESET” with [TUNING MODE].
2 Press [TUNING (X or W)] to select the channel.