Filter
Top Products
Advanced Operations
En-60
Main Menu Hardware Setup
Multi Zone
■ Zone 2 Out
`Fixed
:
The Zone 2 volume must be set on the amp in that
zone.
`Variable:
The Zone 2 volume can be set on the AV receiver.
If you’ve connected your Zone 2 speakers to an amp with
no volume control, set the “Zone 2 Out” setting, to
“Variable” so that you can set the volume, balance, and
tone of zone 2 on the AV receiver.
■ Zone 2 Maximum Volume
`Off, 30 to 79
With this setting, you can limit the maximum volume for
Zone 2.
■ Zone 2 Power On Volume
`Last
, Min, 1 to 79 or Max
This setting determines what the volume will be for Zone 2
each time the AV receiver is turned on.
To use the same volume level as when the AV receiver was
last turned off, select “Last”.
The “Zone 2 Power On Volume” cannot be set higher
than the “Zone 2 Maximum Volume” setting.
Tuner
■ AM/FM Frequency Step (North American
models)
`10kHz/200kHz
:
`9kHz/50kHz:
Select the frequency step according to your area.
■ AM Frequency Step (European models)
`10kHz:
`9kHz
:
Select the frequency step according to your area.
For AM/FM tuning to work properly, you must specify the
AM/FM frequency step used in your area.
Note
• When this setting is changed, all radio presets will be deleted.
HDMI
■ HDMI Control(RIHD)
`Off
`On
Turn this setting on to allow
-compatible
components connected via HDMI to be controlled by the
AV receiver (➔ page 86).
Note
• When the setting is set to “On” and the menu is closed, the names
of connected -compatible components and “RIHD On”
are displayed on the AV receiver.
“Search…” → “(name)” → “RIHD On”
When the AV receiver cannot receive the name of the component,
it is displayed as “Player
*
” or “Recorder
*
”, etc. (“
*
” shows up
and indicates the number of components, when two or more are
received).
• When an -compatible component is connected to the
AV receiver via an HDMI cable, the name of the connected
component is displayed on the AV receiver’s display. For
example, while you are watching TV broadcasting, if you operate
a Blu-ray Disc/DVD player (being powered on) with the remote
control of the AV receiver, the name of the Blu-ray Disc/DVD
player will be displayed on the AV receiver.
• Set it to
“Off” when a connected piece of equipment is not
compatible or it is unclear whether the equipment is compatible
or not.
• If operation is not normal when set to
“On”, change the setting to
“Off”.
• Refer to the connected component’s instruction manual for
details.
• When the “HDMI Control(RIHD)” setting is set to “On”, the
power consumption on standby mode slightly increases.
(Depending on the TV status, the AV receiver will enter standby
mode as usual.)
• When the source equipment is connected with the
connection, it may malfunction if “HDMI Control(RIHD)” is
set to “On”.
Hardware Setup
1234 5
“Setup”