Filter
Top Products
Advanced Operations
En-59
OSD Setup
■ On Screen Display
`On
`Off
This preference determines whether operation details are
displayed on-screen when an AV receiver function is
adjusted.
Even when “On” is selected, operation details may not be
output if the input source is connected to an HDMI IN.
■ Language
`English
, Deutsch, Français, Español, Italiano,
Nederlands, Svenska,
This setting determines the language used for the on-screen
menus.
■ Screen Saver
`3min
, 5 min, 10 min
`Off
With this setting, you can set the time until the screen saver
activates itself. Once active, the screen saver will go off
and the screen will return to its previous state if the AV
receiver is operated in any way.
12V Trigger A/B/C Setup
Depending on their type, when some components are
turned by using triggers A, B, and C, a large amount of
current may be drawn at once. To prevent this, you can
delay each trigger signal individually. Another application
of trigger delay is to eliminate the “thump” noise that’s
sometimes heard when a source component is turned on.
You can accomplish this by delaying the trigger signal for
your power amplifier, so that it’s the last component to be
turned on.
■ Delay
`0sec, 1sec, 2sec, 3sec:
When “0sec” is selected, the trigger signal is output
as soon as the input source is changed.
Note
• By default, “12V Trigger A Setup” is set to “0sec”, “12V
Trigger B Setup” to “1sec”, and “12V Trigger C Setup” to
“2sec”.
• Use a miniplug cable to connect the AV receiver’s 12V
TRIGGER OUT A, B, or C jack to the 12 V trigger input of a
connected component.
■ BD/DVD, CBL/SAT, GAME, PC, AUX, TUNER,
TV/CD, NET, USB, EXTRA1, EXTRA2
`Off:
No trigger signal is output.
A 12-volt trigger signal is output when the connected
component is selected as the source for:
`Main, Zone 2, Main/Zone 2
Tip
•“EXTRA1” and “EXTRA2” can only be selected if they are
assigned.
•“EXTRA1” and “EXTRA2” can be selected as input sources in
“Input” of “Quick Setup” (➔ page 43).
Note
• Except for “EXTRA1” and “EXTRA2” which are set to “Off”,
all input sources on the “12V Trigger A Setup” menu are set to
“Main”, those on “12V Trigger B Setup” are set to
“Main/Zone 2”, and those on “12V Trigger C Setup” are set to
“Zone 2” by default.