Filter
Top Products
Advanced Operations
En-53
Theater-Dimensional
■ Listening Angle
`Wide
:
Select if the listening angle is greater than 30 degrees.
`Narrow:
Select if the listening angle is less than 30 degrees.
With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of the
front left and right speakers relative to the listening
position. Ideally, the front left and right speakers should be
equidistant from the listening position and at an angle close
to one of the two available settings.
Note
• For best results, we recommend setting “
Narrow” to 20° and
“Wide” to 40°.
Main menu Source Setup
Items can be set individually for each input selector.
Audyssey
®
■ Audyssey
`Off
`Movie:
Select this setting for movie material.
The Audyssey indicator will light.
`Music:
Select this setting for music material.
The Audyssey indicator will light.
Note
• When “Audyssey Quick Start” has been used for measurement,
“Audyssey” cannot be selected.
• Audyssey equalizing does not work with DSD sources.
■ Dynamic EQ
`Off
`On:
Audyssey Dynamic EQ
®
becomes active.
The Dynamic EQ indicator will light.
With Audyssey Dynamic EQ, you can enjoy great sound
even when listening at low volume levels.
Audyssey Dynamic EQ solves the problem of deteriorating
sound quality as volume is decreased by taking into
account human perception and room acoustics. It does so
by selecting the correct frequency response and surround
volume levels moment-by-moment so that the content
sounds the way it was created at any volume level — not
just at reference level.
■ Reference Level
Audyssey Dynamic EQ Reference Level Offset
`0dB:
This should be selected for movie contents.
`5dB:
Select this setting for content that has a very wide
dynamic range, such as classical music.
`10dB:
Select this setting for jazz or other music that has a
wider dynamic range. This setting should also be
selected for TV content as that is usually mixed at
10 dB below film reference.
`15dB:
Select this setting for pop/rock music or other
program material that is mixed at very high listening
levels and has a compressed dynamic range.
Front left speaker Front right speaker
Listening angle: 30°
Source Setup
Preparation
Press the input selector buttons to select an input source.
The tone for each speaker is set automatically by
Audyssey 2EQ
®
Room Correction and Speaker Setup.
To enable the following settings, you must first perform
the Room Correction and Speaker Setup (➔ page 32).
• These technologies cannot be used when:
–a pair of headphones is connected, or
–either Pure Audio (European models) or Direct
listening mode is selected.
1234 5
“Setup”
To be continued