Filter
Top Products
OCTOBER 2006 VXA-320 TAPE DRIVE
73
INDEX
using to set SCSI ID 10
See also SCSI ID jumper block
L
labels
agency 62 to 64
identification and configuration 5
LEDs
cleaning indicator 23
definition of all states 20 to 21
location 3
over-temperature indicator 21, 26
power-on sequence 13, 16
service indicator 20
load cycles specification 51
load/unload time 51
M
mean time between failures (MTBF) 51
mean time to repair (MTTR) 51
media
See cartridges
messages
Abort Task Set (06h) message 40
Disconnect (04h) message 39
Extended Messages (01h) 39
Identify (80h or C0h) message 40
Ignore Wide Residue (23h) 40
Initiator Detected Error (05h) message 39
Message Parity Error (09h) message 40
Message Reject (07h) message 40
No Operation (08h) message 40
Restore Pointers (03h) message 39
Save Data Pointers (02h) message 39
Target Reset (0Ch) message 40
Task Complete (00h) message 39
mid-tape reposition time 51
model number 5
models 1
mounting configurations for the internal
model 12
mounting orientation 1, 8
N
noise levels 55
O
on/off switch
See power switch
operating environment 56 to 61
operating system
compatibility 18
tape drive problems 27
operating the tape drive 19 to 24
overvoltage protection 54
P
packaging specifications 61
packing the tape drive 35
part number for tape drive, locating 5
particulate contamination limits 59
partitions, supported by tape format 50
performance specifications 50
phases, SCSI bus 38
pin assignments
power connector 53
SCSI connector 42
POST 13, 16, 20
power cable
connecting to external SCSI tape drive 16
connecting to internal tape drive 12
power connector
location (external model) 4
location (internal model) 3
pin assignments 53
power LED, location (external model) 3
power specifications
AC power consumption, external tape
drive 55
DC voltages, internal tape drive 54
power connector requirements, internal tape
drive 53
power consumption, internal tape drive 54
power supply, external tape drive 55
power switch (external model) 4
product identification, changing for software
compatibility 18
R
read and write specifications 50
read reliability 51
Reed Solomon error detection 50