Filter
Top Products
OCTOBER 2006 VXA-320 TAPE DRIVE
7
UNPACKING THE TAPE DRIVE
2
INSTALLATION
This chapter provides step-by-step instructions for installing the internal and
external models of the VXA-320 tape drive. The information in this chapter
expands on the instructions in the Quick Start guide that accompanied your
tape drive.
UNPACKING THE TAPE DRIVE
All Tandberg Data tape drives are tested, inspected, and carefully packaged at
the factory. However, because shipping damage can occur, you should follow
the steps below to unpack the tape drive:
1. Visually inspect the shipping container and notify your freight carrier
immediately if you see any damage.
2. Place the shipping container on a flat, clean, stable surface. If parts are
missing or the equipment is damaged, notify your supplier or Tandberg
Data.
3. Save the original shipping container and packaging materials in case you
need to reship the tape drive.
INSTALLING THE TAPE DRIVE
The installation instructions for your tape drive depend on what model you
have:
To install the internal LVD SCSI model of the tape drive, read “Installing the
Internal SCSI Tape Drive,” beginning on page 8.
To install the external LVD SCSI model of the tape drive, read “Installing the
External SCSI Tape Drive,” beginning on page 14.