Filter
Top Products
51
GB
Additional Information
Menu item Function Parameters Factory setting Reference page(s)
Pitch Changes the playback speed by auto steps. –48 to +2 0 40
Pfine Fine controls the playback speed. –98.5 to +12.5% 0% 41
Ain
Adjusts the analog signal level input through
the LINE (ANALOG) IN jacks.
–∞ to +12.0dB 0.0dB 17
Coax
–∞ to +18.0dB 0.0dB 17
Opt Adjusts the digital signal level input through
the DIGITAL OPTICAL IN connector.
–∞ to +18.0dB 0.0dB 17
Aout Adjusts the analog signal level output to
the LINE (ANALOG) OUT and PHONES jacks.
–20.2 to 0.0dB 0.0dB 24
Sleep Sets the duration of Sleep Timer. 30/60/90/120min 60min 42
Sleep Turns Sleep Timer on or off. On/Off Off 42
To recall a factory setting
Press CLEAR while selecting the parameter.
Self-Diagnosis Function
The deck’s self-diagnosis function automatically checks the condition of the MD deck when an error occurs, then issues a
three-digit code and an error message on the display. If the code and message alternate, find them in the following table
and perform the indicated countermeasure. Should the problem persist, consult your nearest Sony dealer.
Three-digit code/Message Cause/Remedy
C11/Protected The inserted MD is record-protected.
, Take out the MD and close the record-protect slot (page 16).
C13/REC Error The recording was not made properly.
, Set the deck in a stable surface, and repeat the recording procedure.
The inserted MD is dirty (with smudges, fingerprints, etc.), scratched, or substandard in quality.
, Replace the disc and repeat the recording procedure.
C13/Read Error The deck could not read the TOC on the MD properly.
, Take out the MD and insert it again.
C14/Toc Error The deck could not read the TOC on the MD properly.
, Insert another disc.
, If possible, erase all the tracks on the MD (page 32).
C71/Din Unlock The sporadic appearance of this message is caused by the digital signal being recorded. This will not affect
the recording.
While recording from a digital component connected through the DIGITAL IN connector, the digital
connecting cable was unplugged or the digital component turned off.
, Connect the cable or turn the digital component back on.
Adjusts the digital signal level input through
the DIGITAL COAXIAL IN jack.