Sony MDS-JE530 Stereo System User Manual


 
16
GB
Recording on MDs
6 If necessary, locate the point on the MD to start
recording from.
If you want to record on a new MD or start recording
from the end of the recorded portion, go to step 7.
To record over from the beginning of an existing MD
track
Turn AMS (or press ./> repeatedly) until the
number of the track to be recorded over appears.
To record over from the middle of an MD track
Turn AMS (or press ./> repeatedly) until the
number of the track to be recorded over appears, then
press H to start playback. Press X at the point you
want to start recording from.
7 Press REC z.
The deck changes to recording pause.
8 If necessary, adjust the recording level.
For details, see “Adjusting the Recording Level” on
page 17.
9 Press H or X.
Recording starts.
10 Start playing the programme source.
Operations you may want to do during recording
To Press
Stop recording x
Pause recording X
Resume recording after pausing H or X
Eject the MD A EJECT after stopping
recording
When you pause recording
The track number increases by one. For example, if you
paused recording while recording track 4, the track
number will be 5 when you resume recording.
To prevent accidental erasure of the recorded
material
To make it impossible to record on an MD, slide the
record-protect tab in the direction of the arrow (see
illustration below) to open the slot. To enable recording,
close the slot.
Recording on an MD
Bottom side of the MD
Record-protect tab
Slide in the direction
of arrow
z
To play the tracks you just recorded
Press H immediately after stopping recording.
The deck starts to play from the first track of the material just
recorded.
z
To play from the first track of the MD after recording
1 Press x again after stopping recording.
2 Press H.
The deck starts to play from the first track of the MD.
Notes
• If you switch REC MODE during recording or recording pause,
recording stops.
• Monaural mode allows you to record about twice as much
material as stereo.
• Even if you set REC MODE to MONO, the monitor signal
during recording does not become monaural.
• You can’t record over existing material when Shuffle Play (page
27) or Programme Play (page 27) has been selected.
“Impossible” appears in the display at this time.