Filter
Top Products
Getting Started/Basic Operations
9
Basic Operations
Playing a CD
To turn on the system, press ?/1 (power).
?/1 (power)
To Do this
Stop play Press CD x.
Pause Press CD HS. The S indicator
on the CD HS button lights
orange. Press again to resume play.
Select a track Press MD/CD .m or
M> repeatedly.
Find a point in a
track
Keep pressing MD/CD .m
or M> during play and
release it at the desired point.
“—OVER—” appears at the end
of the CD.
Remove the CD Press CD Z.
Adjust the
volume
Turn VOLUME.
Tips
• If there is no CD in the player, “No Disc” appears
in the display.
• You can switch from another source to the CD
player and start playing a CD just by pressing CD
HS (Automatic Source Selection).
• You can start playing from the desired track in
step 2.
1 Press MD/CD .m or M> repeatedly
until the desired track appears.
2 Press CD HS.
Or, press the number buttons on the remote.
The playback automatically starts. To enter track
numbers 10 or over, press >10 and the track
number. To enter 0, use the 10/0 button.
Notes
• Do not use a CD with tape, seals or paste on it as
this may damage the CD player.
• Do not push the disc tray to close it, as this may
damage the CD player. Press CD Z to close the
disc tray.
• If you switch the function to TUNER, “CD”
remains lit in the display even if you remove the
CD. To turn off “CD”, press FUNCTION
repeatedly until a function other than TUNER
appears in the display.
To close the disc tray, press CD Z again.
2 Press CD HS.
The disc tray closes and play starts.
The H indicator on the CD HS button
lights green.
Track number Playing time
With the label side
up. When you play a
single CD, place it
on the inner circle of
the tray.
2
1
FUNCTION
VOLUME
CD x
MD/CD
.m/M>
1 Press CD Z and place a CD on the disc
tray.