Filter
Top Products
Basic Operations
13
Recording from the
radio
— Manual Recording
You can analog record a radio program on an MD.
If you use a partially recorded MD, recording
starts after the recorded tracks. To erase the
recorded contents, see “Erasing recordings” on
page 40.
To turn on the system, press ?/1 (power).
?/1 (power)
To Do this
Turn off the radio Press ?/1 to turn off the
system.
Adjust the volume Turn VOLUME.
To select the preset number
using the remote
Press the number buttons on the remote in step 3.
To enter preset numbers 10 or over, press >10 and
the preset number. To enter 0, use the 10/0 button.
Listening to non-preset radio
stations
• Press TUNING MODE repeatedly until
“MANUAL” appears in step 2, then press
TUNING + or – to tune in the desired station
(Manual Tuning).
• Press TUNING MODE repeatedly until
“AUTO” appears in step 2, then press TUNING
+ or –. The frequency indication changes and
the scanning stops when the system tunes in a
station (Automatic Tuning).
To cancel Automatic Tuning
Press TUNING MODE.
Tips
• You can switch from another source to the tuner
just by pressing TUNER/BAND (Automatic
Source Selection).
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna (see page 60).
• When an FM stereo program has static noise, press
STEREO/MONO until “MONO” appears. There
will be no stereo effect, but the reception will
improve. Press the button again to restore the stereo
effect.
With the arrow
pointing toward
the deck
2 Press TUNER/BAND to select “FM” or
“AM”.
3 Press TUNING MODE repeatedly until
“PRESET” appears.
continued
With the label
side up, and the
shutter on the
righthand side
3
62
45
MD Z MD x
1 Insert a recordable MD.