Filter
Top Products
56
GB
Making a digital recording on
an MD
1 Connect an optical cable.
See “Hooking up optional components” on
page 54.
2 Start recording.
Refer to the operating instructions provided
with the connected component.
Note
When making a digital recording from the CD/DVD
player of this system to an optional component (MD
deck, etc.) connected to the DVD DIGITAL
(OPTICAL) OUT jack, start the optional component
recording in advance.
Making an analog recording
1 Connect the audio cords.
See “Hooking up optional components” on
page 54.
2 Start recording.
Refer to the operating instructions provided
with the connected component.
Note
Audio may be interrupted when:
– SOUND FIELD is pressed.
– the headphones are connected or removed.
– a microphone is connected or removed.
Making an analog recording
from a VIDEO CD to a video tape
1 Connect optional audio cords from
MD (VIDEO) OUT L/R jacks and the
supplied video cord from VIDEO OUT
jack to your VCR.
2 Start recording.
Refer to the operating instructions provided
with the connected component.
Note
You cannot record from a VIDEO CD to an MD
digitally. When you record from a VIDEO CD to an
MD, make an analog recording on MD.
Should you encounter a problem with your
system, do the following:
1 Make sure the mains lead and speaker
cords are correctly and firmly connected.
2 Find your problem in the troubleshooting
checklist below and take the indicated
corrective action.
If the problem persists after doing all of the
above, consult your nearest Sony dealer.
In case of repairing, please bring the entire
system set (except for the speaker) to the service
station.
Recording on a connected
component
Troubleshooting
Problems and remedies
When the ?/1 indicator flashes
Immediately unplug the mains lead and check
the following items.
• Are the system control cables connected
correctly?
• If your system has a voltage selector, is the
voltage selector set to the correct voltage?
Check the voltage for your region, then
make sure the voltage selector is set
correctly.
• Are the + and – speaker cords short-
circuited?
• Are you using the supplied speakers?
• Is anything blocking the ventilation holes
on the rear of the system?
Check all the above items and fix any
problems found. After ?/1 indicator stops
flashing, reconnect the mains lead and turn on
the system. If the indicator still flashes, or if
the cause of the problem cannot be found
even after checking all the above items,
consult your nearest Sony dealer.