Filter
Top Products
10
GB
6 Connect the mains lead to mains.
The demonstration appears in the display.
When you press ?/1, the system turns on
and the demonstration automatically ends.
If the plug does not fit the wall socket,
detach the supplied plug adaptor (only for
models equipped with an adaptor).
7 (Except for European, Russian and
Latin American models)
Set the color system to PAL or NTSC
depending on the color system of your
TV.
The color system is factory set to NTSC for
region code 3 models, and PAL for other
region code models. Each time you perform
the procedure below, the color system
changes as follows:
NTSC y PAL
Use buttons on the CD/DVD player for the
operation.
1 Press ?/1 to turn off the system.
2 Press ?/1 again while holding down X.
The system turns on and the color system
is changed.
Note
When you play back a VIDEO CD recorded in a
different color system from the one you set to the unit,
the picture image may be distorted.
Inserting two size AA (R6)
batteries into the remote
After inserting the batteries, ensure that you
have the COMMAND MODE switch set to
SYSTEM to use the system. When setting to
TV, you can operate a Sony TV.
Operating a Sony TV
You can use the following buttons on the remote
to operate a Sony TV.
* For double digit number, press >10, then the number.
(For example, press >10, then 2 and 5 for entering
25.)
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Tip
With normal use, the batteries should last for about six
months. When the remote no longer operates the
system, replace both batteries with new ones.
To Press
Turn the TV on or off TV ?/1
Switch the TV’s input
source between the TV and
other input sources
TV/VIDEO
Change the TV channels TV CH +/– or number
buttons*
Adjust the volume of the
TV speaker(s)
VOL +/–