Sony CMT-C5 Stereo System User Manual


 
48
Troubleshooting
If you have any problem using this system, use
the following checklist.
First, check that the power cord is connected
firmly and that the speakers are connected
correctly and firmly.
Should any problem persist, consult your
nearest Sony dealer. When bringing the system
in for servicing, be sure to bring the speaker
system (SA-C5B/C5S) along with the main unit
(HCD-C5).
General
There is no sound.
Adjust the volume.
Make sure the headphones are not connected.
Check the speaker connections (see page 6).
There is no sound output during CD-MD High-
Speed Synchro Recording.
Sound comes from one channel, or unbalanced
left and right volume.
Connect the speaker cords properly (see page 6).
Place the speakers as symmetrically as possible.
Connect the supplied speakers.
There is severe hum or noise.
Move the system away from the source of noise.
Connect the system to a different wall outlet.
Install a noise filter (commercially available) to
the power line.
“– –:– –” appears in the display.
Set the clock again (see page 8).
The timer cannot be set.
Set the clock again (see page 8).
Guide to the Serial Copy
Management System
Digital audio components, such as CDs, MDs, and
DATs let you copy music easily with high quality by
processing music as a digital signal.
To protect the copyrighted music programs, this
system uses the Serial Copy Management System that
allows you to make only a single copy of a digitally
recorded source through digital-to-digital
connections.
You can make only a first generation copy*
through a digital-to-digital connection.
That is:
1 You can make a copy of a commercially
available digital sound program (for example,
a CD or MD), but you cannot make a second
copy from the first-generation copy.
2 You can make a copy of a digital signal from a
digitally recorded analog sound program (for
example, an analog record or a music
cassette tape) or from a digital satellite
broadcast program, but you cannot make a
second copy.
* A first-generation copy means a digital recording of
a digital signal made on digital audio equipment.
For example, if you record from this system’s CD
player to the MD deck, you make a first-generation
copy.
System limitations of MDs
(continued)