Filter
Top Products
23
MD — Recording
To add “LP:” at the beginning of a
track name during MDLP recording
“LP:” appears when you try to play the track on
a system that does not support MDLP mode.
This convenient function lets you know at a
glance that the track cannot be played back.
The factory setting is “On”.
1 Press FUNCTION on the remote
repeatedly until “MD” appears in the
display.
2 Press MENU/NO on the remote.
3 Press . or > repeatedly until
“Setup?” appears in the display, and then
press ENTER/YES on the remote.
4 Press . or > repeatedly until “LP
Stamp On” (or “LP Stamp Off”) appears,
and then press ENTER/YES on the remote.
5 Press . or > to select the setting, and
then press ENTER/YES on the remote.
To Select
Add “LP” LP Stamp On (factory
setting)
Cancel adding “LP” LP Stamp Off
6 Press MENU/NO on the remote.
Notes
• The recorded “LP:” is a stamp which appears to
indicate that the track cannot be played back when
you try to play the track on system that does not
support MDLP mode. It does not appear for systems
that support MDLP mode.
• When set to “On”, “LP:” is recorded as the track
name, so the number of characters that can be input
to an MD is reduced. In addition if you divide an
“LP:” track using the Divide function, “LP:” is also
added to the latter track.
Marking track numbers
• Automatically during recording
Track numbers are automatically marked as on
the original source during recording from this
system’s CD player or components connected
to the DIGITAL OPTICAL IN jack. However,
track numbers may not be marked for some
tracks (see page 47). Use the Level Synchro
Recording function to automatically mark track
numbers during recording from this system’s
tuner or components connected to the TAPE IN
jack.
• At any point during recording
You can mark track numbers during manual
recording of any source (see page 24).
• After recording
Use the Divide Function (see page 31).
Marking track numbers
automatically during recording
— Level-Synchro Recording
The Level-Synchro Recording function is
factory set to on, so the track numbers are
automatically marked. If “LEVEL-SYNC”
does not appear during recording, turn on the
Level-Synchro Recording as follows. Track
numbers are automatically marked when the
input signal is continuously below a certain
level for more than 2 seconds and then exceeds
that level.
continued