Filter
Top Products
27
MD — Editing
Before pulling out the power cord
MD editing is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1
to turn off the system. Do not pull out the
power cord before updating the TOC (while
“TOC” is lit) or while updating the TOC (while
“TOC” is flashing) to ensure a complete
editing.
Labeling an MD
— Name Function
You can create titles for your recorded MDs
and tracks as follows.
During recording
If “CD TEXT” lights up or flashes during
recording, you can record the CD TEXT
information onto the MD as follows:
• Automatically during recording
When “CD TEXT” is lit, the CD TEXT
information is automatically recorded.
• Manually during recording
When “CD TEXT” flashes, press NAME
EDIT/SELECT on the remote, and then
press ENTER/YES on the remote to record
the title of the current track.
Note
Depending on the disc, the CD TEXT information
may not be recorded automatically.
After recording
Use Name Function on this page. You can
input a total of approximately 1700 characters
for the disc title and track titles on a single MD.
1 Press FUNCTION on the remote
repeatedly until “MD” appears in the
display.
To label a track, press . or >
repeatedly until the desired track number
appears.
2 Press NAME EDIT/SELECT on the
remote.
The cursor starts flashing.
3 Press NAME EDIT/SELECT on the
remote repeatedly to select the desired
type of character.
The display changes as follows:
Selected AB* (Upper cases) t Selected
ab* (Lower cases) t Selected 12
(Numbers) t Selected AB* (Upper cases)
t …
* Press number 1 repeatedly to display the
following symbols.
‘ – / , . ( ) : ! ?
In addition, when the symbols above appear in
the display, press . or > repeatedly to
display the following symbols.
& + < > _ = ” ; # $ % @
`
continued