Filter
Top Products
36
To cancel presetting
Press MENU/NO on the remote during step 5
through 6.
To tune in a weak station
In step 2, press TUNING MODE on the remote
repeatedly until “MANUAL” appears in the
display, then press TUNING + or – repeatedly
to tune in the station.
To change the preset number
Start over from step 1.
To change the AM tuning interval
(not applicable on the European
model)
The AM tuning interval is factory-preset to 9 kHz (or
10 kHz for some areas). To switch the AM tuning
interval, tune in any AM station first, then turn off the
system. Pressing and holding down FUNCTION, turn
the system back on. When you change the interval, all
the AM preset stations are erased. To change back to
the original interval, repeat the same procedure.
Tip
The preset stations are saved in the system’s memory
for about a day even if you disconnect the power cord
or a power failure occurs.
Tuner
Presetting radio stations
The system can store a total of 30 preset
stations (20 for FM and 10 for AM).
1 Press FUNCTION (or TUNER BAND on
the remote) repeatedly to select FM or
AM.
2 Press TUNING MODE on the remote
repeatedly until “AUTO” appears in the
display.
3 Press TUNING + or –.
The frequency changes as the system scans
for a station. Scanning stops automatically
when a station is tuned in. At that time,
“TUNED” and “STEREO” (for stereo
program only) appear.
4 Press MENU/NO on the remote.
5 Press TUNING + or – repeatedly until
“Memory?” appears, and then press
ENTER/YES on the remote.
A preset number appears in the display.
Perform steps 6 and 7 while the preset
number is flashing.
6 Press TUNING + or – repeatedly to
select the desired preset number.
7 Press ENTER/YES on the remote.
“Complete!” appears, and then the station is
stored.
8 Repeat steps 1 through 7 to preset
other stations.