Filter
Top Products
26
MD — Editing
Before you start editing
Before editing
You can edit an MD only when:
• The MD is recordable.
• The MD play mode is normal play.
Check the following, before editing.
1 Check the tab of the MD to be edited.
If the MD is record protected, “C11” and
“Protected” appear alternately and the MD
cannot be edited.
Slide the tab to close the slot.
2 Press PLAY MODE on the remote in
stop mode repeatedly until both
“PROGRAM” and “SHUFFLE”
disappear.
You can edit the MD only in normal play
mode. You cannot edit the MD in Shuffle or
Program Play.
To cancel the last edit (page 33)
Use Undo Function to cancel the last edit and
restore the contents of the MD to the condition
before the edit.
To quit while editing
Press MENU/NO on the remote.
After editing
Press MD Z to remove the MD or press ?/1
(power) to turn off the system.
“TOC” starts flashing. The TOC is updated and
editing is completed.
Adjusting the recording level
You can adjust the recording level when
recording to an MD from the tuner or from an
optional component connected to the TAPE IN
or DIGITAL OPTICAL IN jack.
1 Press FUNCTION repeatedly to select
the desired source to record.
2 Press REC/REC IT to stand by for
recording.
3 Press MENU/NO on the remote to
display “Setup?”, and then press
ENTER/YES on the remote.
4 Press . or > repeatedly until
“LevelAdjust?” appears, and then
press ENTER/YES on the remote.
5 Press . or > to adjust the
recording level.
While monitoring the sound, adjust to the
optimum level while making sure that
“OVER” does not appear in the display at
the loudest portion.
6 Press ENTER/YES on the remote.
7 Press MENU/NO on the remote.
8 Press x.
To continue and record, follow the
procedures described on the various
recording pages.
Tips
• You can also adjust the recording level during
recording.
• Once adjusted, the recording level is maintained
until you adjust it again.
Recording tips (continued)