Filter
Top Products
134
GB
Sound
Symptom Remedy
There is no sound. • The speaker cord is not connected securely.
• Press on the remote if “MUTING ON” is displayed in the front panel
display.
• The system is in pause mode. Press H to return to normal play mode.
• Fast forward or fast reverse is performed. Press H to return to normal play
mode.
• Check the speaker settings (page 110).
No sound is output from the
HDMI OUT jack.
• The HDMI OUT jack is connected to a DVI (Digital Visual Interface) device
(DVI (Digital Visual Interface) jacks do not accept audio signals).
• Try the following: 1 Turn the system off and on again. 2 Turn the connected
component off and on again. 3 Disconnect and then connect the HDMI cable
again.
• Set [Audio (HDMI)] in [HDMI Settings] to [TV+AMP] (page 125).
The Super Audio CD sound of a
component that is connected to
the HDMI1 or HDMI2 jack is
not output.
• HDMI1 and HDMI2 does not accept an audio format that contains copy
protection (page 143). Connect the analog audio output of the component to the
SAT/CABLE IN (AUDIO R/L) or TV (AUDIO IN R/L) jacks of the unit.
The left and right sounds are
unbalanced or reversed.
• Check that the speakers and components are connected correctly and securely.
There is no sound from the
subwoofer.
• Check the speaker connections and settings (pages 54, 110).
• Select “
A.F.D. STD” for the decoding mode (page 86).
Severe hum or noise is heard. • Check that the speakers and components are connected securely.
• Check that the connecting cords are away from a transformer or motor, and at
least 3 meters (10 ft) away from your TV set or a fluorescent light.
• Move your TV away from the audio components.
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with
alcohol.
• Clean the disc.
The sound loses stereo effect
when you play a CD.
• Select stereo sound by pressing
(page 90).
• Make sure the unit is connected properly.
The surround effect is difficult to
hear when you are playing a
sound track of Dolby Digital,
DTS, or MPEG audio.
• Make sure the decoding mode setting
(page 86).
• Check the speaker connections and settings (pages 54, 110).
• Depending on the BD/DVD, the output signal may not be the entire 5.1 channel.
It may be monaural or stereo even if the sound track is recorded in Dolby
Digital or MPEG audio format.
The sound comes from the center
speaker only.
• Depending on the disc, the sound may come from the center speaker only.
No sound is heard from the
center speaker.
• Check the speaker connections and settings (pages 54, 110).
• Make sure the decoding mode setting
(page 86).
• Depending on the source, the effect of the center speaker may be less
noticeable.
• A 2 channel source is being played.
No sound or only a very low-
level sound is heard from the
surround speakers.
• Check the speaker connections and settings (pages 54, 110).
• Make sure the decoding mode setting
(page 86).
• Depending on the source, the effect of the surround speakers may be less
noticeable.
• Check the wireless setting (page 67).
• A 2 channel source is being played.