Filter
Top Products
M10 Re:system
32
Defining the main room
With the Main Room softkey, you
switch the state of the main room
(M51 or M10*) between:
Included (On)
Included (Off)
Not Included
Included (On)
The main room is actively
switched on when the scene is
called. Source and volume are
defined in two steps.
Included (Off)
The main room is actively
switched off when the scene is
called.
Not Included
The room is not an active element
of the scene It retains its current
status.
The number of active zones and
rooms is shown in the centre of the
display.
*
In the case of an M10 installation, the
speaker integrated in the M10 is
defined as the main room.
Defining additional rooms
You change the status of the
additional room between Yes and
No with the Rooms softkey. The
assignment is done by zone. You
select the required zone or room
through the Zone and Select
softkeys.
Yes: The additional room is
actively switched ON or OFF
when calling the scene. The
individual setting for the
corresponding room is done in
Step 2.
No: The additional room is not an
active element of the scene. It
retains its current status.
- : This additional room is not
present in the Multiroom system
and therefore cannot be defined.
Once all additional rooms have
been defined, this fact can be
confirmed with the OK softkey.