Filter
Top Products
M10 Re:system
25
Remote Function
The modularity of the M10
requires a flexible usage of
operating units, as the M10 can
be equipped with a wide range of
modules. An operating unit can,
for example, be the M218 Wall-
mounted keypad or the M208
Remote control.
The Remote function offers the
option of always being able to
modify the source selection for
the installed modules to the
operating unit.
This means that the Tuner key on
the M218 operating unit always
sends the same signal over the
Multiroom module to the M10.
Only once the M10 has been
assigned through in the Remote
menu, will the decision be made
as to which source the Tuner key
calls and/or controls. So, for
example, with one installation, the
Tuner key calls the FM Tuner on
the tuner module while with
another, it calls the SAT tuner
from the satellite module.
In general, you can say that
variables defined through the
Remote menu (Tuner, AUX1,
etc.) are assigned to actual
sources, (FM tuner, SAT tuner,
etc.).
Zone-dependant Remote menu
The Revox Multiroom system has 4
Multiroom zones where different
music can be heard independently
of each other.
Now, for example, the M10 enables
you to install 4 FM Tuners that can
all be programmed independently
of each other. Through the zone-
dependent Remote menu, it is now
possible that the Tuner key can
control a different FM tuner in each
zone.
This means that the M10 recog-
nises which zone the variable
Tuner was sent from and knows
from the assignment made through
the Remote menu which source
should be addressed.
The Remote menu settings are
explained in the following chapter.