Filter
Top Products
M10 Re:system
24
M-Text Mode
The selection of the M-Text mode
is only relevant if an UDP port is
used as a port.
If, on the other hand, the TCP/IP
port 5524 is used, the M-Text
mode setting is irrelevant.
M-Text Mode: Forced
The M10 status message is only
sent in M-Text format. Only M-
text commands are expected.
The Forced setting may not be
used if M-Link protocols are used
as well.
M-Text Mode: Auto
The Ethernet interface identifies
automatically which protocol is
present and automatically
switches the mode and retains
this until the next packet is
received in a different mode.
The Auto setting should be
selected if both the M-Text and
M-Link protocols are used. The
mode check that is made in the
Auto setting however, makes the
data exchange slower.
Source - Menu
Using the Source softkey, you
can access the setup menu for
the plug-in module that is
currently playing in Zone 1 and
there you can make the required
settings for this module. The
audio signal from this source can
also be heard through the
integrated speaker or the
headphone socket.
Example:
To modify the base settings for the
tuner, first select the Tuner source in
the Source menu (Source key).
Now, using the Source softkey in
the setup menu, you make the
settings for the tuner.
If, on the other hand, you want to
modify the basic settings of the
Multiroom module installed in the
M10, select the Multiroom
softkey in the setup menu.
You will find the options for the
various basic settings in the
Operating instructions for the
corresponding module.