Revox M10 Speaker System User Manual


 
M10 Re:system
14
USB-B connection for PC
There is an USB-B interface both
on the front and the back of the
M10 that can be operated from a
PC.
Both USB interfaces are switched
in parallel and for this reason
should never be used at the
same time. Use either the front
or the rear USB interface.
The M10 setup and the module
installation can be done using the
Revox M230 or M-Scope PC
programs.
Working with these programs and
the M10 configuration are des-
cribed in a later chapter.
Firts operation
The M10 is connected to a Note-
book or PC using the supplied
USB cable.
After connecting, a Windows
message appears on the screen
that a new device has been
recognised with the name Revox
M10-USB Link. The
corresponding driver must be
installed to set the unit up. See
next chapter: Installing the USB
driver
Installing the USB driver
As the Revox USB driver is not yet
present on the Windows operating
system, you will be asked to make
the corresponding driver available.
Revox recommends not taking
the Windows option to “search for
Driver” but to tell Windows which
folder the driver is in manually.
Following the installation of M-
Scope, you will find the correct
driver for the M10 in the folder C:\
Programme\ Revox\ M-Scope\
USB Driver under the name
M51usb.sys
Follow the Windows installation
instructions and remove the USB
cable from the M10 after
successfully completing the driver
installation.
When you then reconnect the
M10 to the Notebook/PC, the
M10 should now be recognised
automatically.
Note:
Each USB chip in the M10 has an
individual code that is stored by
Windows. For this reason, the
driver installation must be carried
out again for each new M10.