Filter
Top Products
M10 Re:system
18
Connection
Point-to-Point
A Crossover cable is used if the
M10 is connected directly to a
PC.
Distribution with Router
A Patch cable (1:1) is used of the
two devices are connected over a
router.
You will find an overview of a
possible Ethernet network on the
next page. The defined IP
addresses are only examples and
must be modified to meet the needs
of the particular installation.
DHCP is not supported by the
M10. This means that all the
necessary settings for a fault-free
integration of the M10 in an
Ethernet system must be made
manually. You will find details
about this in the Chapter M10
Setup.