Revox M10 Speaker System User Manual


 
M10 Re:system
27
Select button variable
Using the Button softkeys, you
select the button variable that you
want to assign to a specific audio
source at the M10. You can
toggle backwards and forwards
through a loop of the four button
variables with Button+ and
Button-.
The remote button Tuner
symbolises, for example, the
Tuner button on the M218 Wall-
mounted keypad.
Note
One special option is to select
TV-Hold instead of TV/Video.
With this button variable, you
activate the TV/Video source with
a longer press on the button. A
shorter press has no effect. In this
way, conflicts between the M10
and the remote controls from
some televisions can be
effectively avoided.
The TV button must be disabled if
using TV-Hold, otherwise TV-
Hold is ineffective.
The TV button is only available
with remote controls, but not with
wall-mounted keypads.
Select source
Using the two Source softkeys, an
audio source is assigned to the
previously selected button variable,
e.g. Tuner, which will be activated
through the selection with the
operating unit at the M10. You can
toggle backwards and forwards
through a loop of the audio
sources that the M10 currently
offers, with Source+ and Source-
If the same audio source in the
other zones should also be
activated with the same,
previously selected Remote
button, this completes the
required setting. You can check
whether the same setting is
actually present in the other
zones with the Zone softkey. This
is shown through the setting:
- Zone x -
Remote button
xxx
is selecting
the same as
Zone 1