M10 Re:system
23
Page TCP/IP
The second page in the UDP/IP
setup is responsible for all the
UDP settings. Here, all the
relevant settings for the UDP
address and port are made, as
well as the selection of the M-
Text modes.
The new settings are confirmed
with the Apply softkey. Otherwise
the previous setting is retained.
UDP/IP Address ➮ [ ]
UDP/IP address:
Here you can enter the target
address, if the UDP packet should
only be sent to one specific
recipient.
Using the setting 255.255.255.255
the data packet is sent in Broad-
cast mode to all who have opened
the UDP/IP port defined below, e.g.
04032.
UDP/IP Port
In order to ensure data security,
not all ports are available but only
those listed below. These have
been defined by Revox
.
Open ports:
- TCP/IP via Telnet Port 23
(for testing purposes)
- TCP/IP via Port 5524
- UDP/IP via Ports 4032, 5524,
6536, 7728, 8728, 10308,
18042, 24022, 27944, 31286