Filter
Top Products
Using other functions
09
68
En
2 Press DIMMER repeatedly to change the
brightness of the front panel display.
Tip
• Switching the dimmer to lowest setting will also
switch off the MCACC and i.LINK indicators.
Switching the speaker impedance
• Default setting:
Speaker 8
ΩΩ
ΩΩ
You can use speakers with a nominal impedance
between 6–16
Ω
but if you are using speakers with an
impedance of less than 8
Ω
, you must change the
impedance setting below.
• With the receiver in standby, press
STANDBY/
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
•
Speaker 6
ΩΩ
ΩΩ
– Use this setting if your speakers are
rated lower than 8
Ω
(down to 6
Ω
).
•
Speaker 8
ΩΩ
ΩΩ
– Use this setting if your speakers are
rated 8
Ω
–16
Ω
.
Advanced remote control features
Note
• You can cancel or exit any of the following steps by
pressing
REMOTE SETUP
.
• After one minute of inactivity, the remote goes to
sleep. Press any button to reactivate the remote
display and continue.
Editing remote control display names
You can rename what appears in the display on the
remote control for the
MULTI CONTROL
buttons (such
as
DVD/LD
or
TV/SAT
), or for individual buttons for each
input source. You may want to do this if the component
connected to the inputs doesn’t correspond to the
MULTI CONTROL
button name, or individual commands
don’t correspond to their respective buttons.
1 Press and hold REMOTE SETUP for three seconds.
The
REMOTE SETUP
menu appears in the remote control
display.
2 Use
/
(cursor up/down) to select ‘FuncName’
or ‘Key Label’ from the menu and press ENTER.
Select Function Name
(
FuncName
) if you want to rename
a
MULTI CONTROL
button.
Select Key Label
(
KeyLabel
) if you want to rename a
command button (you can rename individual command
buttons for each input source).
Select Function
flashes in the display.
3 Press the MULTI CONTROL
button for the
component.
If you selected Function Name
(
FuncName
) above, go to
step 5.
If you selected Key Label
(
KeyLabel
) above,
Select Key
flashes in the display.
DVD/LD
VCR2
ENTER
VIDEO CD
TV/SAT
TV CONT
MULTI CONTROL
VCR1 /
DVR
CD-R/
TAPE1
MD/
TAPE2
TUNER
REMOTE
SETUP
VSX-AX5Ai.book 68 ページ ２００４年６月２日 水曜日 午後３時２７分